December 19, 2018 9:09 AM

Author Topic: Tube Coping Calculator  (Read 2932 times)

0 Members and 1 Guest are viewing this topic.

Offline AntiBling

  • Suedes Member
  • Traditionalist...or...I post to much.
  • *
  • Posts: 1090
  • Karma: +0/-0
    • View Profile
    • http://antibling.deviantart.com
Tube Coping Calculator
« on: December 26, 2008 7:38 PM »
Well I've had this on my links for awhile figured I'd put it here, it will generate a pattern you can cut out and wrap around a tube to mark the cuts you make for coping a tube.  Good tool for those of us without a tubing notcher.

http://www.metalgeek.com/static/cope.pcgi

DeuceKustoms

  • Guest
RE: Tube Coping Calculator
« Reply #1 on: December 27, 2008 4:40 AM »
cool, thanks!

Offline Serious

  • Suedes Member
  • Traditionalist...or...I post to much.
  • *
  • Posts: 1259
  • Karma: +0/-0
    • View Profile
RE: Tube Coping Calculator
« Reply #2 on: December 27, 2008 7:27 PM »
wow that is cool.

Offline AntiBling

  • Suedes Member
  • Traditionalist...or...I post to much.
  • *
  • Posts: 1090
  • Karma: +0/-0
    • View Profile
    • http://antibling.deviantart.com
RE: Tube Coping Calculator
« Reply #3 on: December 27, 2008 7:44 PM »
Well my first attempt with it failed, but if I would've read I think I would've figured out my problem, it says PDF is the best method to print, but make sure you turn page scaling off.

My first template wouldn't wrap around the tube and was way too deep of cuts.  We'll see how it goes today.

DeuceKustoms

  • Guest
RE: Tube Coping Calculator
« Reply #4 on: December 29, 2008 12:29 AM »
good heads up thanks