December 05, 2025 11:03 am
« previous next »
Pages: [1]   Go Down

Author Topic: A Piston Pounder  (Read 3823 times)

0 Members and 1 Guest are viewing this topic.

Offline racerjohnson

  • Traditionalist...or...I post to much.
  • *
  • Posts: 1379
  • Karma: +0/-1
  • Gender: Male
    • View Profile
A Piston Pounder
« on: September 25, 2007 4:48 pm »
Wanted: an individual who is good at pounding pistons out of a block. Hammer, punch required, torch, and other employee benefits will be supplied.
Logged
The problem with having an artistic eye is that you always end up making more work for yourself. -Cleatus on the HAMB

Offline Eyeball

  • Moderator
  • Traditionalist...or...I post to much.
  • *
  • Posts: 6865
  • Karma: +2/-0
  • Gender: Male
    • View Profile
RE: A Piston Pounder
« Reply #1 on: September 25, 2007 6:09 pm »
Since you make no mention of the resulting condition of the block ......... I am your man. Where do I apply?
Logged
soaken wet shoes and winkled fingers...
hours and hours
inch at a time...

henryj1951 HAMB

Offline Tom

  • Traditionalist...or...I post to much.
  • *
  • Posts: 3436
  • Karma: +1/-0
    • View Profile
Re: RE: A Piston Pounder
« Reply #2 on: September 25, 2007 6:47 pm »
Quote from: "Eyeball"
Since you make no mention of the resulting condition of the block ......... I am your man. Where do I apply?


ha ha .......you guys are tooooooo funny.

Can you say cylinder wall sleeve??
Logged
"A rat rod is a hot rod with poor workmanship". Roger S.
Pages: [1]   Go Up
« previous next »