Author Topic: sko check this out. (Read 4769 times)

31Rodder · « **on:** December 10, 2006 4:51 am »

http://www.bismanonline.com/display_ad.bmo?ad=238165

31Rodder · « **Reply #1 on:** January 02, 2007 4:33 pm »

http://www.jalopyjournal.com/forum/showthread.php?t=124496
another 57 ford 9 inch. $125 Rochester, mn

overspray · « **Reply #2 on:** January 03, 2007 11:13 pm »

I'm using that 8 inch I got from you trading. I found a 3.55 pumpkin at Brady's for it. The 35 Plymouth artillery wheels fit right on. Tom and I went to the "combine" junkyard last week. I picked up this frame (that I have walked by for about 8 years) off a mid 20's Dodge (brothers). I have it in the shop where it will undergo a study session while listening to oldies and sitting on the shop stool. Some time with the tape measure and a loose "mock-up" will determine if it will do the trick. I like the lines and the kick-up in the rear. I'll have to narrow it slightly for a channel.

overspray

Eyeball · « **Reply #3 on:** January 03, 2007 11:38 pm »

That is a neat lookning frame. It looks like it may kick (sweep) up a bit at the front too.

overspray · « **Reply #4 on:** January 04, 2007 3:08 pm »

No, but it might when I'm done. "Large" Gary was over last nite and we measured it for the 31 cowl. It looks like I can channel the homemade RPU over the rails, add some different crossmembers and box it up. The rear kick is about 4 inches. I might as well cut up them 32 frames for parts. I'll take your torque tube out first.

overspray

Tom · « **Reply #5 on:** January 04, 2007 3:45 pm »

Quote from: "overspray"

. I might as well cut up them 32 frames for parts. I'll take your torque tube out first.

overspray

ha ha ha!!! I take the left front 4 feet. ha ha