1
Wanted / 47 dodge box/fenders
« on: December 29, 2013 7:09 pm »
Looking for a 47 dodge box and fenders... Let me know what you have or if have leads on one. Thanks
December 05, 2025 7:19 am
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Project Reports / Re: J_Swisher's 46 Ford
« on: October 25, 2013 8:44 am »
So plugging away trying to get more accomplished. Powerwashed the motor and tranny. Still plan on going through, but easier to work with when they're clean. Ordered a set of fenderwell headers from speedway, the ones for 55-57 chevy. Maybe not perfect, but will work. Did a dry run and seem to fit with where the motor and body is at. Did a lot of trial and error to get them to run through the fenders and seem to fit pretty descent.
3
General Discussion / Louvers
« on: October 14, 2013 1:04 am »
Is there someone that does a good job doing louvers thats local? And the contact information for them. Thanks
4
Project Reports / Re: J_Swisher's 46 Ford
« on: September 22, 2013 2:43 pm »
So more parts painting and put front suspension together.. have some fine tuning, but will work for now... making progress and off the blocks for now... still a ways to go, crazy how much small stuff goes into making stuff fit
5
Project Reports / Re: J_Swisher's 46 Ford
« on: September 22, 2013 2:37 pm »
After lots of cutting the inner fenders finally cleared the front suspension... then some more cutting to make room and look descent.. andfinally fit...
6
Project Reports / Re: J_Swisher's 46 Ford
« on: September 22, 2013 2:30 pm »
So rolled outside to do a little cleanup... and start putting the brakes/spindles together.. original plans were for a 57 ford rear end, but after getting it home and taking a blaster to it.. wasn't much left.. so swapped for a Chevy bolt pattern and stuck together.. the cheesy wheels are just temps..
7
Project Reports / Re: J_Swisher's 46 Ford
« on: September 22, 2013 2:08 pm »
So body went on... and definately not low enough... already has blocks in the rear.. so readjust and more work, but needs a channel...
9
Project Reports / Re: J_Swisher's 46 Ford
« on: September 22, 2013 1:56 pm »
So after getting it sorted out.. kept the seats.. fit pretty descent.. transmission.. no brainer... and rear end...and went to work.
10
Project Reports / Re: J_Swisher's 46 Ford
« on: September 22, 2013 1:28 pm »
So after a little break for life... time to get back to work..have had a few hiccups along the way... but time to get moving again. So found a 74 nova for $300. Took bout everything and anything I could... sold some, kept some, junked some, and came out $100 to the positive
Pages: [1]