Suedes Car Club

Swap Meet => Wanted => Topic started by: Eyeball on October 03, 2008 5:17 pm

Title: Banjo rear *****THANKS OVERSPRAY*****
Post by: Eyeball on October 03, 2008 5:17 pm

Looking for a 39-48 banjo rear. Looking for one with a good surface where the outter bearings run.

Title: banjo
Post by: tracywiedrich on October 04, 2008 12:56 am

I p.m'd you Tim...

Title: RE: banjo
Post by: eberhama on October 04, 2008 1:19 am

I've got a '46-'48 rear, no bones or spring but everything else is there, don't know what shape the bearing surface is like, $75. Its here in moorhead.

Title: RE: banjo
Post by: Tom on October 04, 2008 3:21 am

If you don't find one with good outer ends, they make sleves that will go over the end. You do need to turn end down for them to press on.

Title: RE: banjo
Post by: racerjohnson on October 04, 2008 5:18 am

I turned mine down and put the sleeves on. Worked relatively  well. The first one did anyways. . . but .001 interference is no match for a hammer and a block of wood as long as the sleeve is still warm. ;)

Title: Banjo rear *****THANKS OVERSPRAY*****
Post by: overspray on October 05, 2008 6:44 pm

I have a 39 without brakes and drums.  I picked it up at the roadster swap last year for $50 and I don't know why, maybe because it came out of a barn stored car with about 60,000 miles on it and I figured someday Eyeball would need one.  It looks pretty nice.  I had it sold in Bismarck, but no show on the buyer.

$50 or trade for ???

Title: Banjo rear *****THANKS OVERSPRAY*****
Post by: Eyeball on October 05, 2008 8:07 pm

I'll take it. R u going to the roadster swap? Is the torque tube n drive shaft on it?

Title: Banjo rear *****THANKS OVERSPRAY*****
Post by: overspray on October 06, 2008 12:49 am

No torque tube or shaft.  

I'm still up in the air on the Swap.  I haven't nailed the day off yet.

I'll be in touch.