Suedes Car Club

General => Project Reports => Topic started by: Tom on January 02, 2008 8:32 pm

Title: Hammerform
Post by: Tom on January 02, 2008 8:32 pm

Wanted to make a bubble to cover the cowl steering where it exited the mod. Made this hammer form AND the mallet ( out of an old base ball bat). Tried with some aluminum I had and it's not working out. Gona try again after I get some alum that they recommend.

Title: RE: Hammerform
Post by: Eyeball on January 02, 2008 8:55 pm

I will be looking for updates on this....looks great so far.

Title: RE: Hammerform
Post by: sko_ford on March 25, 2008 1:28 pm

hey tom theres a thread on hte hamb about this. hows yours coming?

Title: RE: Hammerform
Post by: Tom on March 25, 2008 2:01 pm

Thanks Ross I'll have to check it out. Had to set it aside when I started baggin the 4d. Now that I got that done I'll have to get back on it.

Title: RE: Hammerform
Post by: Eyeball on March 25, 2008 2:05 pm

Got it done? Lets see some pics!

Title: RE: Hammerform
Post by: Tom on March 25, 2008 2:31 pm

Yeah I did..........but it's wasn't running worth a shit. I had just rebuilt the carb, so it the carb right?? WRONG!! Like Tracy says 90% of his carb problems are ignition.( right Tim??) The springs on the mech advance on the dizzy were shot. Changed out the distributor and it works much better. Of course only took a day and a half to figure that out!! :x

Title: RE: Hammerform
Post by: pinstriper40 on March 26, 2008 4:56 pm

I want to try this too- I'll let you figure out the hard stuff first though Tom!