Suedes Car Club

Tech Q and A => Running Gear => Topic started by: 31Rodder on October 18, 2006 7:27 am

Title: Spalding Flamethrower
Post by: 31Rodder on October 18, 2006 7:27 am

Can anyone id this shaft?
6 inches from seating surface to bottom of shaft
Shaft opening is hex shaped.

Title: RE: Spalding Flamethrower
Post by: Tom on October 18, 2006 3:41 pm

Todd, check this link.

http://www.jalopyjournal.com/forum/showthread.php?t=109011

Title: Re: RE: Spalding Flamethrower
Post by: Tom on October 18, 2006 3:44 pm

Quote from: "Tom"

Todd, check this link.

http://www.jalopyjournal.com/forum/showthread.php?t=109011

Never mind I see you found it. :oops:

Title: RE: Re: RE: Spalding Flamethrower
Post by: 31Rodder on October 18, 2006 4:58 pm

yes i resurrected that one from the dead.

Title: RE: Re: RE: Spalding Flamethrower
Post by: Tom on October 18, 2006 6:10 pm

Looks like ya need a y-block. ha ha

Title: RE: Re: RE: Spalding Flamethrower
Post by: Ryan on October 21, 2006 4:01 am

I know where there is one!

Title: RE: Re: RE: Spalding Flamethrower
Post by: sundance on October 23, 2006 4:06 pm

and i know where there are two more!!