46
Newbie Intros / Re: Hello from Fargo/Moorhead
« on: September 20, 2012 3:20 PM »
Welcome to the board any pictures
May 16, 2024 9:47 PM
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
48
Newbie Intros / Re: Hey I made it on here...again
« on: July 13, 2012 4:41 AM »
Nice. Now stop lurking and post pics
49
Project Reports / Re: Ford Model A Roadster
« on: June 12, 2012 8:49 PM »
I have to chassis totally disassembled now and am getting the frame all cleaned up for paint.
50
Event Announcements / Re: Is Art Olson coming up?
« on: May 11, 2012 1:13 AM »
I believe it's on the 20th
52
General Discussion / Re: Ebay thread II
« on: March 09, 2012 5:03 PM »
http://minneapolis.craigslist.org/csw/rvs/2877418450.html
It is a 1963 Bethany Travelling Teepee. Here are some pictures.
It is a 1963 Bethany Travelling Teepee. Here are some pictures.
53
Project Reports / Re: 31 Model A coupe
« on: February 15, 2012 3:05 AM »
Looks like it is ready to go.
55
Project Reports / Re: Ford Model A Roadster
« on: January 06, 2012 7:02 PM »
The are from socal speed shop. chrome bell mouth velocity stacks
56
Project Reports / Re: Ford Model A Roadster
« on: January 03, 2012 5:05 AM »
I got 4 nice and shiny chistmas presents.
57
Project Reports / Re: Jake's "A"
« on: January 03, 2012 4:57 AM »
I better get busy Jake, you are going to beat me done.
58
General Discussion / Re: NDSRA Christmas Party
« on: December 29, 2011 7:15 PM »
the grand is sold out for saturday night. still have rooms for friday.
60
Project Reports / Re: Ford Model A Roadster
« on: December 04, 2011 5:39 AM »
I couldn't use stock Model A radiator support rods as they were too short. I looked at Speedway and saw they carried radiator support rods in stainless for around 25 bucks plus another 13 for shipping so I decided to make a pair. I went to Mac's and saw the 5/16 round sticks were around 4 bucks for a 3 foot stick. Nearby I saw the fence posts 5/16 nearly 4 feet long so, I picked up 2 fence posts for a buck and a half each and a few nuts bolts and washers everything was less that 4 dollars. It was pretty simple just made a point on the ends of the bolts and the end of the fence post and welded them together. measured for length. I then cut the 4 1/2 inch bolt in half to use for the threaded ends, ground to a point on each end same on the raw fence post end and welded up. saved myself 34 bucks. plus it got me back out in the shop again.