Tech Q and A > Tools

Welding tip size chart

<< < (2/4) > >>

Tom:

--- Quote from: "JakesBackyard" ---
--- Quote from: "Tom" --- Set for natural flame, have a small enough tip for the job.
--- End quote ---


I think you mean "neutral flame".   :)
--- End quote ---


Yes I did :roll: I must have clicked on the wrong word when I used spell check. :shock: Thanks.

Eyeball:

--- Quote from: "Tom" ---
--- Quote from: "JakesBackyard" ---
--- Quote from: "Tom" --- Set for natural flame, have a small enough tip for the job.
--- End quote ---


I think you mean "neutral flame".   :)
--- End quote ---


Yes I did :roll: I must have clicked on the wrong word when I used spell check. :shock:
--- End quote ---


FIXED IT

In Pete's notes from the Winfied class Gene recommended a smith AW1-A torch. Mine is an AW-100 the only diff I can see on line is that mine has the valves at the base of the torch and the other has them up where the tip goes. Probably a better balance but they both take the same tips. I can't tell for sure if it is smaller but in the pics I have found they are about the same size.

Eyeball:
Jake you say a #1 or #2. I assume that is the AW201 and AW202 tip. I have seen some posts that say use a 00 which may be the AW200 for 18-20ga and a 0 tip wich I think is the AW20 tip for 16ga. Not sure which one to order.

JakesBackyard:
Hang on.....Don't order yet.....I'll do some digging around here.

Eyeball:
Thanks Jake, I will be in touch in the next few weeks.

Navigation

[0] Message Index

[#] Next page

[*] Previous page