December 07, 2024 8:44 am
« previous next »
Pages: [1]   Go Down

Author Topic: Special Stainless tig rod - looking for advice  (Read 6498 times)

0 Members and 1 Guest are viewing this topic.

Offline tokyo

  • Suedes Member
  • Oh, I get it...
  • *
  • Posts: 347
  • Karma: +0/-0
  • Gender: Male
  • dongs!
    • View Profile
    • My50merc
Special Stainless tig rod - looking for advice
« on: November 11, 2014 2:19 pm »
So i have alot of extra stainless trim from the merc - all 4 door - both beltline and upper trim.  I probably have enough to put about 4 sets of coupe trim together.  What i don't have is any knowledge about what stainless rod i may need to tig them together. 

Anyone have an idea what i may need to get?

thanks - tok
Logged
I once had a really big deck.

Offline AntiBling

  • Suedes Member
  • Traditionalist...or...I post to much.
  • *
  • Posts: 1090
  • Karma: +0/-0
    • View Profile
    • http://antibling.deviantart.com
Re: Special Stainless tig rod - looking for advice
« Reply #1 on: November 11, 2014 3:04 pm »
Get a roll of stainless MIG wire, you won't find a TIG rod smaller than MIG wire and it'd be better for that thin material.  309 should be fine. 
Logged

Offline tokyo

  • Suedes Member
  • Oh, I get it...
  • *
  • Posts: 347
  • Karma: +0/-0
  • Gender: Male
  • dongs!
    • View Profile
    • My50merc
Re: Special Stainless tig rod - looking for advice
« Reply #2 on: November 18, 2014 12:34 am »
thanks man.
Logged
I once had a really big deck.
Pages: [1]   Go Up
« previous next »